Efek Pretreatment Terhadap Pembentukan Lapisan Cake dan Struktur Membrane pada Membran Ultrafiltrasi Aliran Cross-flow dalam Pengolahan Limbah Cair Emulsi Minyak

Suprihanto Notodarmojo1¹, T. Zulkarnain^1,2, Dini Mayasanthy² & M. Irsyad¹

¹Departemen Teknik Lingkungan Fakultas Teknik Sipil dan Perencanaan, Institut Teknologi Bandung, Jl.  Ganesha No.10, Labtek IXc, Bandung 40132

²Departemen Teknik Kimia, Politeknik Ujungpandang, Sulawesi Selatan

A study on the effect of pretreatment on the use of cellulose acetate (CA) membrane using cross-flow system to treat oil-water emulsion waste came from metal cutting process of an automotive industry has been done. The objectives of this research are to see the impact of pretreatment process to flux and cake forming, indicated by cake forming constant (k’), and to study membrane structure. The ultra filtration process performance was determined by obtaining the values of permeate flux and rejection. The material of membrane used in this process was cellulose acetate membrane with 12 % of cellulose acetate composition for first stage operation and 15 % for second stage operation. The duration of the process was 90 minutes operation time, by applying operation pressure at 3, 5 Bar.  There were two types of feeding mode applied, the first was feeding without pretreatment and the second was feeding with pretreatment. After some operation periods, the permeate flux decreases due to fouling. On the first stage of membrane operation, for waste without pretreatment, we obtained the value of k’= 0,0004 m²/L and for waste with pretreatment k’= 0,0001 m²/L. On the second stage membrane operation, for waste without pretreatment the value of k’= 0,0009  m²/L and for waste with pretreatment k’= 0,0002 m²/L. The results mean that pretreatment reduce significantly formation of the cake. It was also obtained that the structure of the membrane is asymmetric. It was shown that deposition of contaminant also occurs within the spinger of the membrane (inner structure of the membrane). Deformation of the membrane spinger was also observed. It is concluded that pretreatment applied to feeding solution increase the running time of the membrane. The benefit of membrane operation used feed with pretreatment, beside increases permeate fluks also decreases the cake forming constant which will longer operation time of membrane.

Download Article